Prepare
Practice
MCQs
CBSE MCQs
Engineering MCQs
Online Test
Writing
Create CV
Character Counter
Trending Post
Latest Jobs
Theory of Machines Test Questions
Home
>>
Category
>>
Mechanical Engineering Questions
>>
Theory of Machines Test Questions
>> In a Hooke's joint, maximum velocity ratio between driving and driven shaft is possible if θ is
« Previous
Next »
Engineering MCQs
CBSE MCQs
Q. In a Hooke's joint, maximum velocity ratio between driving and driven shaft is possible if θ is
a.
0
b.
π
c.
2 π
d.
all of the above
ANSWER: all of the above
Answer & Explanation
No explanation is available for this question!
« Previous
Next »
Related Content
Piezometer is used to measure___________...
The number of electrons in 1 cm3 of meta...
In spot welding, the spacing between two...
What is the degree of subcooling?
In jet engines the compression ratio____...
The specific fuel consumption of a petro...
Which of the following alloying elements...
Pick up the incorrect statement from the...
A fast breeder reactor uses_____________...
In a hydraulic circuit a pump is provide...
The pressure and temperature at the end ...
German silver is an alloy of____________...
The basic requirement of a good combusti...
Cylinder clearance in a compressor shoul...
What is the frictional torque acting on ...
Pick up the wrong statement ?
The internal reaction in bottom 80 cm le...
From a circular plate of diameter 6 cm i...
Which one of the following represents a ...
The efficiency of Carnot cycle is maximu...
Under-cooling in a refrigeration cycle__...
A fuel will detonate less if it has_____...
The compression ratio in a jet engine va...
Which dimensions can be measured using i...
The heat pump
The shearing stresses in the inner face ...
A big advantage of PERT over Gantt chart...
Which type of arc welding is suitable fo...
If V, U and Vr represent the absolute ve...
Carnot cycle is
Discussion
➨
Post your comment / Share knowledge
Counter
Online Test
MCQs
Trending
Latest Jobs
▲