1) __________________ has relatively wider range of speed control? a. Synchronous motor b. Ship ring induction motor c. Squirrel cage induction motor d. D.C. shunt motor
|
||||
2) Rotor of a motor is usually supported on ___________________ bearings? a. ball or roller b. needle c. bush d. thrust
|
||||
3) The size of an excavator is usually expressed in terms of_________________? a. ‘crowd’ motion b. angle of swing c. cubic metres d. travel in metres
|
||||
4) _________________method of starting a three phase induction motor needs six terminals ? a. Star-delta b. Resistance starting c. Auto-transformer d. None of the above
|
||||
5) Which of the following is essentially needed while selecting a motor ? a. Pulley b. Starter c. Foundation pedal d. Bearings
|
||||
6) In a paper mill where constant speed is required________________? a. synchronous motors are preferred b. A.C. motors are preferred c. individual drive is preferred d. group drive is preferred
|
||||
7) For blowers which of the following motor is preferred ? a. D.C. series motor b. D.C. shunt motor c. Squirrel cage induction motor d. Wound rotor induction motor
|
||||
8) Reluctance motor is a________________? a. variable torque motor b. low torque variable speed motor c. self starting type synchronous motor d. low noise, slow speed motor
|
||||
9) A reluctance motor_________________? a. is provided with slip rings b. requires starting gear c. has high cost d. is compact
|
||||
10) ___________________is preferred for synthetic fibre mills? a. Synchronous motor b. Reluctance motor c. Series motor d. Shunt motor
|