MCQs: Lancing is the operation of _________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: In spot welding, the spacing between two spot weld should not be less than _______________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The shrinkage allowance for cast iron pattern is________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Tandem drawing of wires and tubes is necessary because_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The operation of straightening a curved sheet metal, is known as____________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Which of the following statement is wrong ?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Which of the following cycles uses air as the refrigerant__________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The relative coefficient of performance is_____________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Clapeyron equation is applicable for registration at___________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: In vapor compression cycle, the condition of refrigerant is very wet vapor________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: A refrigerant should have _____________________?
Pick up the wrong statement ?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Clapeyron equation is a relation between___________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: In vapor compression cycle, the condition of refrigerant is high pressure saturated liquid________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The boiling point of ammonia is___________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: In S.J. unit, one ton of refrigeration is equal to___________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Allowable pressure on high-pressure side or ammonia absorption system is of the order of_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The condensing pressure due to the presence of non-condensable gases, as compared to that actually required for condensing temperatures without non-condensable gases ____________________ ?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The vapor compression refrigerator employs the following cycle_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The moisture in a refrigerant is removed by___________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: In vapor compression cycle the condition off refrigerant is dry saturated vapor________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|