Chemical Engineering Basics Mcqs

Q.  With increasing carbon percent in steel beyond 0.8%, its ultimate tensile strength (UTS) and _____________ is not affected ?

a. Impact strength
b. Percent elongation
c. Hardness
d. Both B & C


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  Maximum change in the hardness of martensite occurs in the carbon content range of _____________ percent in steel?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Speed of a submarine in deep sea & that of an aeroplane is measured by a/an___________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The main charge in blast furnace is usually___________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Identify the correct statement with reference to the extractive metallurgy of aluminium ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Calorific value of ____________________ are almost same?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  _______________ is not a case hardening process ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The atmospheric temperature during melting of ice/snow (in the atmosphere)_________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Silicon percentage in acid resistant cast iron is about ___________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Thermal equivalent of electrical power in practical calculation is _______________ kcal/kWh ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  One of the methods of purification of leach liquor is ion exchange, which involves_________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The unit of gc is ___________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Notched bar test is used for testing the _________________ of a material?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A material being tested for endurance strength is subjected to the _______________ load ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The most abundant metal present in the earth’s crust is__________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The fugacity of liquid water at 298 K is approximately 3171 Pa. Considering the ideal heat of vaporisation as 43723 J/gm.mole, its fugacity at 300 K would be________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Cold heading or upsetting is categorised as the ________________ process ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which one can be directly solidified from gaseous state without entering into liquid state ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Out of the following, maximum temperature drop for a given heat flow & for the same thickness will be in the case of________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Glass reacts with___________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Lead is added to 60:40 brass primarily to improve_________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts