|
MCQs: Which type of injection laser involves the use of geometry for fabrication of the multimode injection laser with a single or small number of lateral modes?
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: In the dynamic response of Injection Laser Diode (ILD), the delay which is followed by ____ frequency damped oscillations give rise to the generation of relaxation oscillations.
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: The spectral response of an ideal photodetector depicts its efficiency as a function of _________
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: According to frequency response of photo-detector, the modulation frequency at which the output current decreases to ________of peak value.
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: Which photodiodes are crucially applicable to overcome the bandwidth-quantum efficiency trade-off along with its resemblence to the pyramid structure?
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: When an optical signal is incident on a photo-detector, which noise originate/s due to statistical nature of production and collection of photoelectrons?
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: In an eye-diagram, digital signals with very bad interference resembles the shape of _____
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: On which factor/s do/does the response time of photodiode depend/s?
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: Which nature of charge carriers give rise to the current fluctuations thereby resulting into the generation of shot noise?
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: Which among the following parameters is/are decided by the front-end of a receiver?
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: In an optical network, increase in the number of lasers ________the bit rate.
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: Which band/s specify/ies the operation range of Erbium doped fiber amplifier (EDFA)?
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: Basically, solitons are pulses which propagates through the fiber without showing any variation in ______
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: Why is an electrical isolation required between several portions of an electronic circuit?
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: For measuring the shape of input pulse in time-domain intermodal dispersion method, the test fiber is replaced by another fiber whose length is less than ___ of the test fiber.
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: In chromatic dispersion, which parameter for the modulation of the received signal is measured with the help of a vector voltmeter?
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: Which among the following stages is/are adopted in Splice Loss Experiment?
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: Which among the following misalignments give/gives rise to the occurrence of splice loss?
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: Which function/s is/are provided by Integrated Memory Management Unit in 80386 architecture?
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: Which unit in 80386 DX architecture plays a crucial role in the conversion of linear address to physical address?
Category: Electronic Engineering Questions, Published by: teswesm
|
