Metrology & Quality Control Test Questions

Q.  Which type of comparator changes its magnification, when distance between cross strip hinge and knife edge is varied?

a. Johansson mickrocator
b. Solex pneumatic comparator
c. Projector comparator
d. Sigma comparator


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Which among the following is a pull type signaling system?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Imperial standard yard is made of
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In which of the following length standards, parallax error is observed?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Grade 1 is used in
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Testing flatness or straightness of a surface is possible using
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which principle is used to measure distance in electronic comparator?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which error is observed due to lack of squareness when depth is measured using depth micrometer?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following is true for interference fit?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  How is interference between shaft and hole calculated?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which among the following is used to create fringes in N.P.L. interferometer?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which type of light source is used in N.P.L. type of flatness interferometer?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which principle does Taylor-Hobson-Talysurf tester work on?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following methods is unreliable to evaluate the surface finish?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Calculate diameter of best wire for a Withworth thread of M 24 x 7 mm size.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following statements is true?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Calculate the tool width of a gear having 30 number of teeth and with module 5 mm.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A gear has 30 teeth with module 4 mm and pressure angle of 20°. Calculate length of base tangent in a gear over 7 teeth space.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following is a contact type of automated inspection method?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which are the different techniques used by interpretation segments for interpretation?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which formula is used to calculate quality of performance?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts