Metrology & Quality Control Test Questions

Q.  Which principle does Taylor-Hobson-Talysurf tester work on?

a. Capacitive demodulating principle
b. Intensity modulating principle
c. Inductive modulating principle
d. Carrier modulating principle


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  What is/are the factor(s) causing runout?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The snap gauge having go dimension corresponds to
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which type of deviation is observed while calculating hole dimensions?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  At which angle does a glass plate reflector set in N.P.L. interferometer?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which type of surface in a fringe pattern exhibits the movement of fringes towards the centre?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following statements is true?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is ten point height method?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What effect does pitch error have on nut and bolt?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  According to Taylor's principle which type of gauge checks both size and geometric features?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which formula is used to calculate diametral pitch?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Analytical checking of gears includes checking of
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is the function of frame grabber?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In image shearing techniques, what is meant by single shear?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Quality improvement planning is related to which category of cost?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Inadvertent errors are caused due to
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following is the limitation of Quality circle?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Waterfall method is observed in
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which control chart pattern is/are used for assignable causes?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following statements is/are true? 1. Trend type of control chart pattern shows continuous movement of points upwards and downwards 2. Trend pattern occurs due to change in inspection method 3. Downward trend indicates wear of parts
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Maximum data handling analysis load is observed in
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts