MS Access Database Mcqs

Q.  Which option allows us to build a new table by entering data directly into a tabular grid ?

a. Datasheet View
b. Design View
c. LinkedTable
d. Grid View


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  The velocity distribution for laminar flow through a circular tube__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The discharge of a liquid of kinematic viscosity 4 cm2/sec through a 8 cm dia-meter pipe is 3200n cm7sec. The type of flow expected is__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The ratio of average velocity to maximum velocity for steady laminar flow in circular pipes is_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  For laminar flow in a pipe of circular cross-section, the Darcy’s friction factor f is________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  For hydro-dynamically smooth boundary, the friction coefficient for turbulent flow is_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  With the same cross-sectional area and immersed in same turbulent flow, the largest total drag will be on__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The distance y from pipe boundary, at which the point velocity is equal to average velocity for turbulent flow, is________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In case of an airfoil, the separation of flow occurs________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The depth ‘d’ below the free surface at which the point velocity is equal to the average velocity of flow for a uniform laminar flow with a free surface, will be_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If x is the distance from leading edge, then the boundary layer thickness in laminar flow varies as________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  For a sphere of radius 15 cm moving with a uniform velocity of 2 m/sec through a liquid of specific gravity 0.9 and dynamic viscosity 0.8 poise, the Reynolds number will be_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The discharge over a broad crested weir is maximum when the depth of flow is_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following has highest coefficient of discharge ?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The major loss of energy in long pipes is due to_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Coefficient of velocity for Borda’s mouth piece running full is________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The pressure at the summit of a syphon is_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Due to each end contraction, the discharge of rectangular sharp crested weir is reduced by________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The theoretical value of coefficient of contraction of a sharp edged orifice is_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The pitot tube is used to measure________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Equation of continuity is based on the principle of conservation of_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts