Tunnel Engineering Mcqs


Q.  Which one of the following tunnelling methods is used for laying under ground sewers ?

a. Needle beam method
b. Army method
c. German method
d. Italian method


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  An open tank contains 1 m deep water with 50 cm depth of oil of specific gravity 0.8 above it. The intensity of pressure at the bottom of tank will be________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The total pressure on a plane surface inclined at an angle 9 with the horizontal is equal to_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Centre of buoyancy always_________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Metacentric height for small values of angle of heel is the distance between the________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  A rectangular block 2 m long, 1 m wide and 1 m deep floats in water, the depth of immersion being 0.5 m. If water weighs 10 kN/m3, then the weight of the block is________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  If a vessel containing liquid moves downward with a constant acceleration equal to ‘g’ then_____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  An open cubical tank of 2 m side is filled with water. If the tank is rotated with an acceleration such that half of the water spills out, then the acceleration is equal to_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The horizontal component of force on a curved surface is equal to the_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The eddy viscosity for turbulent flow is______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  In a two dimensional incompressible steady flow around an airfoil, the stream lines are 2 cm apart at a great distance from the airfoil, where the velocity is 30 m/sec. The velocity near the airfoil, where the stream lines are 1.5 cm apart, is_________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  If the velocity is zero over half of the cross-sectional area and is uniform over the remaining half, then the momentum correction factor is_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The continuity equation pi V,A,= p2V2A2 is based on the following assumption regarding flow of fluid______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The motion of air mass in a tornado is a________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Stream lines and path lines always coincide in case of__________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  In steady flow of a fluid, the total accele ration of any fluid particle______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following is used to measure the discharge ?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Size of a venturimeter is specified by________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The discharge through a V- notch varies as______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Coefficient of velocity of venturimeter_________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Coefficient of discharge for a totally submerged orifice as compared to that for an orifice discharging free is__________________?
Category: Civil Engineering Mcqs,   Published by: teswesm