MCQs: In a scissors cross-over, the crossings provided are_________________?
i) 2 obtuse angle crossings
ii) 4 obtuse angle crossings
iii) 4 acute angle crossings
iv) 6 acute angle crossings
The correct answer is ?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The reception signal is__________________?
i) outer signal
ii) home signal
iii) starter
iv) advanced starter
The correct answer is?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: To ensure exact gauge, the gauge tie plates are provided at_________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: In a B.G. railway track, the specified ruling gradent is 1 in 250. The horizontal curve of 3° on a gradient of 1 in 250 will have the permissible gradient of__________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: If ‘A’ is the angle formed by two gauge faces, the crossing number will be____________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: If the thickness of thinnest outside plate is 10 mm, then the maximum pitch of rivets in tension will be taken as______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: When the axis of load lies in the plane of rivet group, then the rivets are subjected to________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: Bending compressive and tensile stresses respectively are calculated based on_________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: When the axis of load lies in the plane of rivet group, then the most heavily loaded rivet will be the one which________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The difference between gross diameter and nominal diameter for the rivets up to 25 mm diameter is__________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: If the thickness of plate to be connected by a rivet is 16 mm, then suitable size of rivet as per Unwin’s formula will be__________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The heaviest I-section for same depth is_________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: Which of the following types of riveted joint is free from bending stresses ?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: In a gusseted base, when the end of the column is machined for complete bearing on the base plate, then the axial load is assumed to be transferred to base plate__________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: By providing sufficient edge distance, which of the following failures of riveted joint can be avoided ?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: As compared to field rivets, the shop rivets are________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: Efficiency of a riveted joint, having the minimum pitch as per IS : 800, is_________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: Bolts are most suitable to carry_________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: When the bolts are subjected to reversal of stresses, the most suitable type of bolt is________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The effective length of a fillet weld should not be less than___________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|