Metrology & Quality Control Test Questions

Q.  Which of the following statements is/are true?

a. Pyrometer is a non-contact type of instrument
b. Stroboscope is a contact type of instrument
c. Micrometer is a non-contact type of instrument
d. All of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Lot Tolerance Percent Defective is also known as?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is the effect of sample size on probability of acceptance?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is meant by Kaizen?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which among the following is a pull type signaling system?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Imperial standard yard is made of
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In which of the following length standards, parallax error is observed?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Grade 1 is used in
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Testing flatness or straightness of a surface is possible using
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which principle is used to measure distance in electronic comparator?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which error is observed due to lack of squareness when depth is measured using depth micrometer?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following is true for interference fit?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  How is interference between shaft and hole calculated?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which among the following is used to create fringes in N.P.L. interferometer?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which type of light source is used in N.P.L. type of flatness interferometer?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which principle does Taylor-Hobson-Talysurf tester work on?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following methods is unreliable to evaluate the surface finish?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Calculate diameter of best wire for a Withworth thread of M 24 x 7 mm size.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following statements is true?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Calculate the tool width of a gear having 30 number of teeth and with module 5 mm.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A gear has 30 teeth with module 4 mm and pressure angle of 20°. Calculate length of base tangent in a gear over 7 teeth space.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts