Metrology & Quality Control Test Questions

Q.  Which of the following statements is/are true? 1. Trend type of control chart pattern shows continuous movement of points upwards and downwards 2. Trend pattern occurs due to change in inspection method 3. Downward trend indicates wear of parts

a. Only 1
b. Only 2
c. Only 3
d. All of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Which dimensions can be measured using image shearing microscope?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which among the following is used to measure velocity of an object?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following statements is/are true according to Deming's Deadly Diseases?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is meant by P, D, S and A in PDSA cycle?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is capability ratio?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following statements is/are true for sampling inspection?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is acceptance quality level?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which quality management program is related to the maintenance of plants and equipments?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The aim of Just-In-Time manufacturing principle is to eliminate
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Calculate the taper angle, if 8 mm and 12 mm are the diameters of A and B balls respectively. Ball A is at a height of 25 mm from the horizontal ground surface and B at 15 mm.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What does N, P and L mean in N.P.L. Gauge interferometer?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is meant by hitch hiking?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Heat transfer deals with the rate of
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which among the following has lowest thermal conductivity among the others?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In gases, the transfer of heat takes place by
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  How does the heat transfer take place in metals?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Internal energy of a substance is associated with
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In which phase of a substance does conduction mode of heat transfer take place?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Mass transfer does not take place in
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is the condition for conduction mode of heat transfer between two bodies?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts