Petroleum Refinery Engineering Mcqs for Chemical

Q.  Which of the following reactions is undesirable in the production of catalytically reformed gasoline ?

a. Dehydrogenation of Naphthene
b. Dehydrogenation of lower paraffins
c. Dehydrocyclization of higher paraffins
d. Isomerisation of paraffins


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  Which of the following is the easiest to crack ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Clay treatment is used to remove ___________________ ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  _____________ chloride present in crude petroleum as impurity is the most prolific producer of HCl during distillation?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Gasoline extracted from natural gas (by compression and cooling) is called the ___________ gasoline?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Catalyst used in the catalytic polymerisation is__________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Crude topping column operates at ________________ pressure?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A typical yield of diesel in straight run distillation of crude oil may be about ________________ percent?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  True vapour pressure of a petroleum fraction ________________ Reid vapour pressure?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The characterisation factor of crude petroleum oil is around__________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Molecular weight of crude petroleum may be around________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Octane number (unleaded) of gasoline produced by isomerisation of butane may be about __________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Refractive index of a petrofuel which is the ratio of velocity of light in air to its velocity in the petrofuel gives an indication if its_________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  ‘Solvent naphtha’ used mostly as a solvent in paints and perfumery is produced by the _________________ of virgin naphtha into small boiling range cuts?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Straight run naphtha is converted into high octane number petrol (gasoline) by catalytic____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which is almost absent in crude petroleum ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Hydrocracking employs ___________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following is a Naphthene ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Preheating temperature of medium viscosity furnace oil for better atomisation through burner is about _______________ °C ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following has the highest flash point of all ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Solvent deoiling process is used for separating oil and soft wax from hard wax. Methyl isobutyl ketone and methyl ethyl ketone (MEK) are two commonly used deoiling solvents. Use of former as the deoiling solvent has the advantages of the____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts