Basic Mechanical Engineering Test

Q.  Which of the following is an extensive property?

a. Volume
b. Pressure
c. Viscosity
d. All of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Which of the following materials do not have a well defined yield point?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Factor of safety is the ratio of _________
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following statements is/are true for alloy steels?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following is a ferrous alloy?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Copper when alloyed with zinc is known as
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The plastic materials which do not undergo chemical change when heated are ____
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following is a characteristic of Polytetra-flouro-ethylene?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following statements is/are true for mechanisms?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which body transmits force with negligible deformation?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is the primary function of mechanism?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following is an inversion of four bar chain?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What are the number of sliding and turning pairs in a slider crank mechanism?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is meant by drag in casting process?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Casting replica used to make the cavity is called as
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The process of joining similar or dissimilar materials by heating them below 450o C using non-ferrous filler material is called as ______
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  At forging temperature when a compressive force is applied on the material, it deforms
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is the average temperature required for hot forging of aluminium alloys?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which process squeezes metals into peaks and troughs with plastic deformation?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following operations is/are performed on a lathe machine?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The process of chamfering the entrance of a drilled hole is known as_____
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts