Basic Mechanical Engineering Test


Q.  Which of the following is a not a surface finishing process?

a. Honing
b. Buffing
c. Lapping
d. Turning


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Why is the load carrying capacity low in ball bearings? 1. Due to line contact between inner race and the ball 2. Due to greater axial dimensions 3. Due to less radial dimensions 4. Due to point contact between inner race and the ball
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Cylindrical roller bearings have greater _____
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Which of the following statements is/are true?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Determine torque transmitted on the pinion shaft if torque transmitted on gear shaft is 20 Nm. Consider Gear ratio = 4
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Which of the following statements is/are true for gear drives?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  In which power transmitting drive polygon effect is observed?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  What is meant by gear ratio?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Which gears are used to connect two intersecting shaft axes?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  In stress-strain diagram, up to proportional limit ______
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Deformation per unit length is called as ________
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Which of the following materials do not have a well defined yield point?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Factor of safety is the ratio of _________
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Which of the following statements is/are true for alloy steels?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Which of the following is a ferrous alloy?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Copper when alloyed with zinc is known as
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The plastic materials which do not undergo chemical change when heated are ____
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Which of the following is a characteristic of Polytetra-flouro-ethylene?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Which of the following statements is/are true for mechanisms?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Which body transmits force with negligible deformation?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  What is the primary function of mechanism?
Category: Mechanical Engineering Questions,   Published by: teswesm