Chemical Engineering Basics Mcqs


Q.  Which of the following heat treatment processes is usually applied to castings ?

a. Tempering
b. Annealing
c. Normalising
d. Carburising


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Carbon supply in pack carburising process is in the form of ___________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Function of gear box is to____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  During sensible cooling of air, its wet bulb temperature ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  During sensible heating of humid air__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Thermal diffusivity of a substance is proportional to (where, k = Thermal conductivity) ____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  _____________ glass is used in the mercury in glass thermometer meant for measuring a temperature of 500°C ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Cold working of a material results in increase in hardness, which is termed as the ______________ hardening ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Transition from laminar flow to turbulent flow in fluid flow through a pipe does not depend upon the___________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Softening of hardened steel is done by its____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Potable water means the water used for____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following gases cause global warming ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Air/fuel ratio by weight for combustion of methane with theoretical quantity of air will be about ____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Photographic plates are coated with _____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The approximate height of a blast furnace having a useful volume of 2000 m3 is about _______________ metres ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Probability of cavitation occuring becomes very high, when the local _______________ resulting ? in water bubbles formation, which on rupture cause cavitation
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  In the diving apparatus, helium is used along with oxygen, because it is ____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Water hammer is caused in steam carrying pipelines, because of ______________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  A fire tube boiler is limited to a maximum steam pressure of about ______________ kg/cm2 ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The underground well of a bio gas plant is called the________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Hot dipping process is used for coating a low melting point metal (e.g. Pb, Sn, Zn) on iron, steel & copper having relatively higher melting points. Which of the following is not a hot dipping process ?
Category: Chemical Engineering Mcqs,   Published by: teswesm