Chemical Engineering Basics Mcqs


Q.  Which of the following has the least value of ultimate tensile strength (UTS) ?

a. Medium carbon steel
b. High carbon steel
c. Cast iron
d. Wrought iron


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Principal alloying elements of cast tool alloys which have very high wear resistance & high temperature strength are ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Breakeven point represents the condition, when the company runs under no profit no loss condition. In break even analysis, total cost comprises of fixed cost________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Property responsible for the talcum powder to cling to the skin is the__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  During decarburising of a plain carbon steel, the thickness of ferrite layer growth is proportional to____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Percentage of differential pressure lost in a Venturimeter with a tapering of 15° may be about___________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  ____________________ flux is used for the extraction of metal from its self fluxing ores?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Uniform ramming of sand in green sand moulding process leads to____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  At the point of boundary layer separation in fluid flow, the _____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  In case of condensers & evaporators operating under given terminal conditions, LMTD (logarithmic mean temperature difference) for counter flow as compared to that for parallel flow is__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  ________________ property of steel increases by addition of large amount of silicon in it?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  When the wavelength of incident X-rays increases, the angle of diffraction__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Liquid nitrogen containers can be made from ___________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  To counteract the bad effects of strain hardening on a cold formed part, it must be ______________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The thermodynamic law, PVy = constant, is not followed by the __________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Material of construction of foundry crucible is _________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  _______________ test determines the yield strength, Young’s modulus of elasticity, percentage reduction in area & percentage elongation of a material ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Bad odour in sanitary latrines is reduced by periodically sprinkling_____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The minimum and the maximum number of members required to form a Private Limited Joint Stock Company are respectively __________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following metals reacts violently with water ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Steel is welded using the ________________ flame ?
Category: Chemical Engineering Mcqs,   Published by: teswesm