Chemical Engineering Basics Mcqs


Q.  Which of the following gives the correct sequence of flow of the flue gases through the above mentioned boiler accessories ?

a. A, C, B, D
b. D, B, C, A
c. D, C, B, A
d. D, A, B, C


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Which of the following is a boiler accessory i.e., not a boiler mounting ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The most important requirement for aluminium industry is the availability of cheap _______________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Steel containing low percentage of nickel, chromium & tungsten are termed as the _____________ steel ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Materials having resistivity ranging from 1 to 100 ohm. cm is termed as___________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Plasma is_____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Heat flow across a hollow sphere of inner radius ‘r1’ and outer radius ‘r2’ is directly proportional to__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Tempering of a material does not improve its____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  In connection with corrosion of metals, passivation is the process that__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  On oscilloscope screen for dynamic measurement, lissajous diagram is normally used to determine the ______________ of the input signal?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following forces does not act on a fluid at rest ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Cold cracking in the heat affected zone of a high strength steel weld can take place because of the___________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Moist climate is the most favourable factor in the site selection far a_________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The most important function of a washer is to provide bearing area and washers are normally specified by their hole diameters. The diameter of washer as compared to the nut is__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Powder metallurgy is used to produce__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Primary designation of steel is based on its__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Wohler test is a destructive test to find out the ___________________ strength of a prepared metal specimen ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The temperature at which ferromagnetic material can no longer be magnetized by the outside forces, is termed as the____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The two elements required to form substitutional solid solution should not have___________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  ____________ test is the appropriate test to determine whether a material is ductile or brittle ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Fire refining process is employed in case of___________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm