Basic Mechanical Engineering Test

Q.  Which of the following component(s) is/are manufactured by powder metallurgy processes?

a. Gears
b. Cutting tools
c. Bearing bushes
d. All of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Determine torque transmitted on the pinion shaft if torque transmitted on gear shaft is 20 Nm. Consider Gear ratio = 4
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following statements is/are true for gear drives?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In which power transmitting drive polygon effect is observed?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is meant by gear ratio?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which gears are used to connect two intersecting shaft axes?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In stress-strain diagram, up to proportional limit ______
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Deformation per unit length is called as ________
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following materials do not have a well defined yield point?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Factor of safety is the ratio of _________
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following statements is/are true for alloy steels?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following is a ferrous alloy?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Copper when alloyed with zinc is known as
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The plastic materials which do not undergo chemical change when heated are ____
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following is a characteristic of Polytetra-flouro-ethylene?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following statements is/are true for mechanisms?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which body transmits force with negligible deformation?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is the primary function of mechanism?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following is an inversion of four bar chain?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What are the number of sliding and turning pairs in a slider crank mechanism?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is meant by drag in casting process?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts