Mechatronics Test Questions

Q.  Which module of data acquisition system (DAQ) consists of the CPU that controls the complete data acquisition system?

a. Input module
b. Output module
c. Sampling module
d. Control module


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  The task of time sharing, in which large number of data signals are sent through cables or buses, is performed by____
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Data acquisition of all the physical quantities in the real world is done in
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  According to Nyquist theorem, the sampling rate should be _________ as fast as the highest frequency of the signal being measured or sampled.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Digital to Analog Conversion is ______________ Analog to Digital Conversion.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Micro-controllers are ________________ than the PLCs.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  How is the noise immunity of PLCs to electrical noises as compared to that of conventional relay controllers?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The capability of convention relay systems for complex operations is ___________ that of the PLCs .
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  How is the speed of operation of conventional relay system as compared to digital controllers?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The type of memory which is fast and temporarily stores the data which are immediately required for use is called as______.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  When ___________ contacts are actuated, they disrupt the power supply through them.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which method is used for stability analysis?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is the ratio of amplitude of response to that of the input called?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In all cases of input frequency, if the gain starts reducing, the phase angle will _______.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If the frequency of the input signal to a system is increased, the amplitude of the output _______.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  __________ is the time required for the response to reach 50% of the final value in the first attempt.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following is/are the drawback/s of proportional control? 1. Proportional control system is complicated and costly. 2. Proportional control system is not suitable for pressure temperature and flow control problems 3. If there are sudden disturbance, the proportional control system takes time to stabilize.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Shifting of set point and adjusting its new value by the controller, when the value of disturbance increases, is called as_______.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The range of control of controller __________ due to presence of offset.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If the value of error increases, the changing speed of controller output __________.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The product of force (F) and time (t) is called as________.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts