MCQs: ________ is the curve plotted between input and output by giving known inputs to an instrument and obtaining corresponding outputs.
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The displacement of a mass attached to a spring in mechanical system is corresponding to _______ in the electrical system
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Which of the following statements are true for block diagrams? 1. Block diagrams are the pictorial representation of the system 2. The complicated systems can be easily represented by connecting different blocks 3. Block diagram represents the relationship between input and output of the system
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: A corresponding block of an element is drawn by inserting ________ of that element inside the block.
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: What is/are the maximum number of arrow/s (Input/s) allowed to go inside the block?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The task of time sharing, in which large number of data signals are sent through cables or buses, is performed by____
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Data acquisition of all the physical quantities in the real world is done in
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: According to Nyquist theorem, the sampling rate should be _________ as fast as the highest frequency of the signal being measured or sampled.
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Digital to Analog Conversion is ______________ Analog to Digital Conversion.
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Micro-controllers are ________________ than the PLCs.
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: How is the noise immunity of PLCs to electrical noises as compared to that of conventional relay controllers?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The capability of convention relay systems for complex operations is ___________ that of the PLCs .
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: How is the speed of operation of conventional relay system as compared to digital controllers?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The type of memory which is fast and temporarily stores the data which are immediately required for use is called as______.
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: When ___________ contacts are actuated, they disrupt the power supply through them.
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Which method is used for stability analysis?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: What is the ratio of amplitude of response to that of the input called?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: In all cases of input frequency, if the gain starts reducing, the phase angle will _______.
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: If the frequency of the input signal to a system is increased, the amplitude of the output _______.
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: __________ is the time required for the response to reach 50% of the final value in the first attempt.
Category: Mechanical Engineering Questions, Published by: teswesm
|