VLSI Design & Technology Test Questions


Q.  Which among the following is/are not suitable for in-system programming?

a. EPROM
b. EEPROM
c. Flash
d. All of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Which UART component/s divide/s the system clock to provide the bit clock with the period equal to one bit time and Bclock x 8?
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  In Gray coding, when the state machine changes state, ______ bit/s in the state vector changes the value.
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  Which type of CPLD packaging comprises pins on all four sides that wrap around the edges of chip?
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  An antifuse element initial provides ______ between two conductors in absence of the application of sufficient programming voltage.
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  In spartan-3 family architecture, which programmable functional element accepts two 18 bit binary numbers as inputs and computes the product?
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  Which level of routing resources are supposed to be the dedicated lines allowing output of each tile to connect directly to every input of eight surrounding tiles?
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  Maze routing is also known as ________
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  Maze routing is used to determine the _______path for a single wire between a set of points, if any path exists.
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  In a chip, which type/s of pad design/s is/are adopted to solve the problem of pin count?
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  The power consumption of static CMOS gates varies with the _____ of power supply voltage.
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  Which factor/s play/s a crucial role in determining the speed of CMOS logic gate?
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  In CMOS circuits, which type of power dissipation occurs due to switching of transient current and charging & discharging of load capacitance?
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  In accordance to the scaling technology, the total delay of the logic circuit depends on ______
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  In two-stage op-amp, what is the purpose of compensation circuitry?
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  According to the principle of current mirror, if gate-source potentials of two identical MOS transistors are equal, then the channel currents should be _______
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  PSSR can be defined as the product of the ratio of change in supply voltage to change in output voltage of op-amp caused by the change in power supply & _______ of op-amp.
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  Which among the following serves as an input stage to most of the op-amps due to its compatibility with IC technology?
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  Which among the following is/are responsible for the occurrence of 'Delay Faults'?
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  Due to the limitations of the testers, the functional test is usually performed at speed _______the target speed.
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  High observability indicates that ________number of cycles are required to measure the output node value.
Category: Electronic Engineering Questions,   Published by: teswesm