MCQs: Which among the following depicts positive and negative relation between driving factor and performance factor?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Which type of chart uses the rule of 20:80?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Which of the following statements is true? 1. P and nP charts cannot use limit gauges 2. P charts are difficult to understand 3. P charts cannot recognize different degrees of defectiveness in units
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Which of the following statements is/are true? 1. Probability of acceptance decreases if acceptance number increases, when sampling size is kept constant 2. Indifferent quality range is the range between lot tolerance percent defective and acceptable quality level 3. Operating characteristics curve is the curve plotted between probability of acceptance and indifferent quality range
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: On operating characteristics curve, consumers risk is denoted by
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: ISO 14000 quality standard is related with
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Which ISO standard is used in international automobile companies to set automotive quality system standards ?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Which of the following is a characteristic of End standard?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Which among the following is measured using four ball method?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Which of the following is true?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Internal diameter of any workpiece can be measured using
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: What is/are the factor(s) causing runout?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The snap gauge having go dimension corresponds to
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Which type of deviation is observed while calculating hole dimensions?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: At which angle does a glass plate reflector set in N.P.L. interferometer?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Which type of surface in a fringe pattern exhibits the movement of fringes towards the centre?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Which of the following statements is true?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: What is ten point height method?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: What effect does pitch error have on nut and bolt?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: According to Taylor's principle which type of gauge checks both size and geometric features?
Category: Mechanical Engineering Questions, Published by: teswesm
|