VLSI Design & Technology Test Questions

Q.  Which among the following EDA tool is available for design simulation?

a. OrCAD
b. ALDEC
c. Simucad
d. VIVElogic


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  In two-stage op-amp, what is the purpose of compensation circuitry?
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  According to the principle of current mirror, if gate-source potentials of two identical MOS transistors are equal, then the channel currents should be _______
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  PSSR can be defined as the product of the ratio of change in supply voltage to change in output voltage of op-amp caused by the change in power supply & _______ of op-amp.
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which among the following serves as an input stage to most of the op-amps due to its compatibility with IC technology?
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which among the following is/are responsible for the occurrence of 'Delay Faults'?
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  Due to the limitations of the testers, the functional test is usually performed at speed _______the target speed.
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  High observability indicates that ________number of cycles are required to measure the output node value.
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  Basically, an observability of an internal circuit node is a degree to which one can observe that node at the _______ of an integrated circuit.
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  The interface between an analog signal and a digital processor is
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  The speech signal is obtained after
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  Telegraph signals are examples of
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  As compared to the analog systems, the digital processing of signals allow 1) Programmable operations 2) Flexibility in the system design 3) Cheaper systems 4) More reliability
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  The Nyquist theorem for sampling 1) Relates the conditions in time domain and frequency domain 2) Helps in quantization 3) Limits the bandwidth requirement 4) Gives the spectrum of the signal
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  Roll-off factor is
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  A discrete time signal may be 1) Samples of a continuous signal 2) A time series which is a domain of integers 3) Time series of sequence of quantities 4) Amplitude modulated wave
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  DTFT is the representation of
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  The transforming relations performed by DTFT are 1) Linearity 2) Modulation 3) Shifting 4) Convolution
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  The DFT is preferred for 1) Its ability to determine the frequency component of the signal 2) Removal of noise 3) Filter design 4) Quantization of signal
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  Frequency selectivity characteristics of DFT refers to
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  The Cooley–Tukey algorithm of FFT is a
Category: Electronic Engineering Questions,   Published by: T-Code Scripts