MCQs: Which among the below mentioned parameters is/are associated with the quality of a device?
Category: Electronic Engineering Questions, Published by: teswesm
|
MCQs: How is the reliability of a product specified?
Category: Electronic Engineering Questions, Published by: teswesm
|
MCQs: Internal feedback or compensation in an amplifier usually compensates for ______
Category: Electronic Engineering Questions, Published by: teswesm
|
MCQs: Reduction in gain of current feedback amplifiers results in low level of accuracy at _________
Category: Electronic Engineering Questions, Published by: teswesm
|
MCQs: he applications provided by CFAs are limited to bipolar transistor because they do not exhibit the necessity of ______
Category: Electronic Engineering Questions, Published by: teswesm
|
MCQs: In μA748 op-amp, the use of 3 pF compensation capacitor also increases the slew rate by the factor of ________
Category: Electronic Engineering Questions, Published by: teswesm
|
MCQs: Which among the following should not be used on clocked elements to perform operational system logistic functions due to high noise susceptibility especially in synchronous design practices?
Category: Electronic Engineering Questions, Published by: teswesm
|
MCQs: Which form of transition results into an existence of a dynamic hazard in synchronous designing?
Category: Electronic Engineering Questions, Published by: teswesm
|
MCQs: Which among the following controls the frequency of onboard multiplex oscillator in 4-digit ICM 7217A LED display?
Category: Electronic Engineering Questions, Published by: teswesm
|
MCQs: Which stage of software designing involves the processes of assembling, compiling, linking and downloading?
Category: Electronic Engineering Questions, Published by: teswesm
|
MCQs: Which among the below mentioned assertions is not a module design criteria for dividing problem into small modulus?
Category: Electronic Engineering Questions, Published by: teswesm
|
MCQs: Which among the below stated flowchart symbols belongs to the category of control flow diagrams?
Category: Electronic Engineering Questions, Published by: teswesm
|
MCQs: What does the word “End do” in a pseudo code imply?
Category: Electronic Engineering Questions, Published by: teswesm
|
MCQs: Which terminology of PCB represents a thin photo-sensitive polymer by supporting photographic pattern of single traces or IC pads for etching?
Category: Electronic Engineering Questions, Published by: teswesm
|
MCQs: The actual cost of PCB can be evaluated on the basis of ________
Category: Electronic Engineering Questions, Published by: teswesm
|
MCQs: Which factors contribute to the occurrence of mechanical stress?
Category: Electronic Engineering Questions, Published by: teswesm
|
MCQs: Which type of PCB requires minimum soldering on component side in order to avoid replacement oriented difficulties?
Category: Electronic Engineering Questions, Published by: teswesm
|
MCQs: What effects can be observed if the separate power and ground planes are provided with large conducting surfaces for better decoupling in PCB layouts?
Category: Electronic Engineering Questions, Published by: teswesm
|
MCQs: Which problems are about to occur if PCB is not designed properly in a confined manner for digital circuits?
A. Diffraction
B. Refraction
C. Ground & Supply-line Noise
D. Electromagnetic Interference
Category: Electronic Engineering Questions, Published by: teswesm
|
MCQs: Which among the following is a terrestrial navigation system that utilizes low frequency radio transmitters and the time interval received from several radio signals in order to determine the position of ship or an aircraft?
Category: Electronic Engineering Questions, Published by: teswesm
|