|
MCQs: In μA748 op-amp, the use of 3 pF compensation capacitor also increases the slew rate by the factor of ________
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: Which among the following should not be used on clocked elements to perform operational system logistic functions due to high noise susceptibility especially in synchronous design practices?
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: Which form of transition results into an existence of a dynamic hazard in synchronous designing?
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: Which among the following controls the frequency of onboard multiplex oscillator in 4-digit ICM 7217A LED display?
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: Which stage of software designing involves the processes of assembling, compiling, linking and downloading?
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: Which among the below mentioned assertions is not a module design criteria for dividing problem into small modulus?
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: Which among the below stated flowchart symbols belongs to the category of control flow diagrams?
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: What does the word “End do” in a pseudo code imply?
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: Which terminology of PCB represents a thin photo-sensitive polymer by supporting photographic pattern of single traces or IC pads for etching?
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: The actual cost of PCB can be evaluated on the basis of ________
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: Which factors contribute to the occurrence of mechanical stress?
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: Which type of PCB requires minimum soldering on component side in order to avoid replacement oriented difficulties?
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: What effects can be observed if the separate power and ground planes are provided with large conducting surfaces for better decoupling in PCB layouts?
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: Which problems are about to occur if PCB is not designed properly in a confined manner for digital circuits?
A. Diffraction
B. Refraction
C. Ground & Supply-line Noise
D. Electromagnetic Interference
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: Which among the following is a terrestrial navigation system that utilizes low frequency radio transmitters and the time interval received from several radio signals in order to determine the position of ship or an aircraft?
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: Fractional bandwidth basically refers to the bandwidth of device, which gets divided by __________
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: Free Space Path Loss (FSPL) is proportional to the square of _________
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: Which among the below mentioned assertions is not a reason responsible for the occurrence of fading?
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: What is the range of SINAD numbers associated with the threshold for reasonable intelligibility of voice especially in SINAD measurement system?
Category: Electronic Engineering Questions, Published by: teswesm
|
|
MCQs: Which among the design characteristics of MUX specifies that the two channels can never be connected instantaneously?
Category: Electronic Engineering Questions, Published by: teswesm
|
