Design of Steel Structures Mcqs

Q.  When the axis of load lies in the plane of rivet group, then the most heavily loaded rivet will be the one which________________?

a. is at the maximum distance from CG of the rivet group
b. is at the minimum distance from CG of the rivet group
c. gives the maximum angle between the two forces Fa and Fm
d. gives the minimum angle between the two forces Fa and Fm


ANSWER: See Answer
 
where, Fa is the load shared by each rivet due to axial load and Fm is the shearing load due to moment in any rivet
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  For a standard 45° fillet, the ratio of size of fillet to throat thickness is_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A circular column section is generally not used in actual practice because________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The best arrangement to provide unified behaviour in built up steel columns is by______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The use of tie plates in laced columns is_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Angle of inclination of the lacing bar with the longitudinal axis of the column should preferably be between____________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The effective length of a battened column is increased by_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The slenderness ratio of lacing bars should not exceed________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Shear buckling of web in a plate girder is prevented by using________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Minimum thickness of web in a plate girder, when the plate is accessible and also exposed to weather, is______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  As per IS : 800, for compression flange, the outstand of flange plates should not exceed________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Bearing stiffener in a plate girder is used to__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Gantry girders are designed to resist_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Rivets connecting flange angles to cover plates in a plate girder are subjected to_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The range of economical spacing of trusses varies from________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Normally, the angle of roof truss with asbestos sheets should not be less than_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Generally the purlins are placed at the panel points so as to avoid__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The relation between intensity of wind pressure p and velocity of wind V is taken as_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The internal pressure coefficient on walls for buildings with large permeability is taken as_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The risk coefficient k, depends on__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Area of openings for buildings of large permeability is more than_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts