MCQs: A thin mild steel wire is loaded by adding loads in equal increments till it breaks. The extensions noted with increasing loads will behave as under_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The ultimate tensile stress of mild steel compared to ultimate compressive stress is__________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Modulus of rigidity is defined as the ratio of_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: It equal and opposite forces applied to a body tend to elongate it, the stress so produced is called______________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The unit of Young’s modulus is__________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Hooke’s law holds good up to____________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The stress developed in a material at breaking point in extension is called__________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Which of the following disciplines provides study of the relative motion between the parts of a machine and the forces acting on the parts__________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Which of the following is a lower pair_______________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The example of lower pair is_______________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: A universal joint is an example of_____________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Pitch point on a cam is_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The example of spherical pair is_____________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: A circular bar moving in a round hole is an example of_______________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: If there are L number of links in a mechanism then number of possible inversions is equal to_______________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The lower pair is a_____________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: In higher pair, the relative motion is_____________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The example of higher pair is_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Which of the following would constitute a link__________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Davis steering gear consists of__________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|