Waste Water Engineering Mcqs

Q.  When drainage to sewage ratio is 20, the peak dry weather flow is_______________?

a. 20% of the design discharge
b. Slightly less than 5% of the design discharge
c. Slightly more than 5% of the design discharge
d. None of these


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  Fresh sewage is generally_____________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  It is customary to design a sewer for D.W.F. on the basis of________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The following is the physical characteristic of sewage___________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  For laying a sewer line in a trench of 2 m width, an offset line is marked on the ground parallel to the given centre line at a distance of___________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The most dangerous pollutant in vehicular emissions is____________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The sewer which collects the discharge from a collecting system and delivers it to a treatment plant, is known_____________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A sewer pipe contains 1 mm sand particles of specific gravity 2.65 and 5 mm organic particles of specific gravity 1.2, the minimum velocity required for removing the sewerage, is_____________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The settlement of a particle in sedimentation tank, is affected by_____________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If the over land flow from the critical point to the drain is 8 km and the difference in level is 12.4 m, the inlet time is________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The minimum recommended diameter of sewers, is_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The suitable cross-section of sewers to carry combined flow, is__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In sewers the highest non-scouring velocity is achieved in________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If D.O. concentration falls down to zero in any natural drainage, it indicates the zone of__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  For trunk and out-fall, the type of sewers generally used, is_____________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The most efficient cross section of sewers in a separate sewerage system is__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The stone ware sewers_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A manhole is classified as shallow if its depth is between_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In case of sewer lines_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In a city the ratio of the drainage to sewage is 20, the percentage discharge passing through non-monsoon periods, is_____________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A circular sewer section is preferred to because__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts