Thermodynamics Test Questions

Q.  What should be the critical temperature of working fluid for maximum efficiency of vapour power cycle?

a. the working fluid should have critical temperature as low as possible
b. the working fluid should have critical temperature as high as possible
c. the critical temperature does not affect the efficiency of the vapour power cycle
d. none of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Humidification is the process of addition moisture in air at
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which device used to separate condensate from the steam without letting steam escape?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The substance which is homogeneous and invariable in chemical composition throughout its mass is called as ____.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The two-property rule statement consists that ____.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Absolute pressure is measured as
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A platinum resistance thermometer has a resistance of 2 ohm at 0° C and 3 ohm at 100° C. What will be the temperature when resistance indicates 5 ohm?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Heat flow is a quantity of heat transfer
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The process in which no heat transfer takes place through boundaries is called as
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Heat transfer is
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The amount of heat required to raise a unit mass of substance through a unit rise in temperature is called as
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The amount of heat transferred to convert unit mass of solid to vapour or vice versa is called as
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which among the following statements are correct? (1) Energy is an extensive property (2) Specific energy is an extensive property (3) Energy is a point function (4) Heat capacity is an extensive property
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A quasi-static process has main characteristics as it is
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A cyclic heat engine operates between a source temperature of 927 °C and a sink temperature of 27 °C. What will be the maximum efficiency of the heat engine?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  PMM2 is the machine which violates ___________
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Exergy is not conserved but destroyed in the process. What is the reason behind this?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What does the exergy principle state?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  People use electric energy to heat and light homes. What does it indicate?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The ratio of minimum exergy which must be consumed to perform the task to the actual amount of energy consumed in performing the same task is called as
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The dryness (x) fraction of superheated steam is taken as
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts