Turbo Machines Test Questions

Q.  What is the formula for forces exerted by fluid on a body?

a. (Rate of momentum in) x (Rate of momentum out)
b. (Rate of momentum in) – (Rate of momentum out)
c. (Rate of momentum in) + (Rate of momentum out)
d. None of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  ___________ pump is also called as velocity pump.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The mass flow rate of air compressed in axial flow compressor is _____________centrifugal compressor.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following is NOT a type of rotary compressor?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The function of _________ is to convert high kinetic energy of gases into pressure energy.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  How is the variation of air velocity while passing through impeller followed by diffuser in centrifugal compressor?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A pair of fixed blade and rotor blade in axial flow compressor is called as _________.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  An axial flow compressors have _______.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  ________ blades are attached to the rotor or spindle.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The basic principle of operation of axial flow compressor is _______that of the centrifugal compressor.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The blade passages in a compressor are ________
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which component of fluid velocity is responsible for transmission of power through rotodynamic machine?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is the head of water available at turbine inlet in hydro-electric power plant called?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Gross head is the difference between __________.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is runaway speed of the runner of Pelton wheel?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The gates of aerofoil section in between the outer and inner ring of guide wheel are called as ________.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following components of reaction turbine increases the head on the turbine by an amount equal to the height of runner outlet above the tail race?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  As the reaction turbine works on the principle of impulse and reaction, it follows the law of ________.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In which type of turbine, the runner needs to be run full of water?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In reaction turbine work is done_______________.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following sentences are correct for steam turbine? 1. Steam turbine requires large floor area 2. Steam turbine is a rotary high speed machine 3. Steam turbine has low weight to power ratio 4. Steam turbine has more initial cost and maintenance cost
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts