Thermodynamics Test Questions


Q.  What is the dryness fraction (x) on saturated vapour line?

a. x = 0
b. x = 1
c. x = 0.9
d. x = 0.5


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  In gas cycle refrigeration system, the throttle valve of a vapour compression refrigerant system is replaced by
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  How much is the temperature drop of real gas by throttling?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The ideal gas-refrigeration cycle is similar to
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The horizontal line in psychrometric chart joining the change of state of air represents
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Air at dry bulb temperature Td1 is passed through the heating coil and some amount of air is by passed unaffected and leaves with dry bulb temperature Tb2 and the temperature of heated air is Td3 (where Td2 < Td3), what is the correct formula for by pass factor (The amount of air by passed unaffected)?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Humidification is the process of addition moisture in air at
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Which device used to separate condensate from the steam without letting steam escape?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The substance which is homogeneous and invariable in chemical composition throughout its mass is called as ____.
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The two-property rule statement consists that ____.
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Absolute pressure is measured as
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  A platinum resistance thermometer has a resistance of 2 ohm at 0° C and 3 ohm at 100° C. What will be the temperature when resistance indicates 5 ohm?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Heat flow is a quantity of heat transfer
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The process in which no heat transfer takes place through boundaries is called as
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Heat transfer is
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The amount of heat required to raise a unit mass of substance through a unit rise in temperature is called as
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The amount of heat transferred to convert unit mass of solid to vapour or vice versa is called as
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Which among the following statements are correct? (1) Energy is an extensive property (2) Specific energy is an extensive property (3) Energy is a point function (4) Heat capacity is an extensive property
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  A quasi-static process has main characteristics as it is
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  A cyclic heat engine operates between a source temperature of 927 °C and a sink temperature of 27 °C. What will be the maximum efficiency of the heat engine?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  PMM2 is the machine which violates ___________
Category: Mechanical Engineering Questions,   Published by: teswesm