Metrology & Quality Control Test Questions

Q.  What is the aim of fool proofing technique used for total quality management?

a. to achieve zero defects
b. to specify time schedules
c. to specify targets
d. none of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Which of the following gives actual measurement of any specific dimension?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Lot Tolerance Percent Defective is also known as?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is the effect of sample size on probability of acceptance?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is meant by Kaizen?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which among the following is a pull type signaling system?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Imperial standard yard is made of
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In which of the following length standards, parallax error is observed?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Grade 1 is used in
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Testing flatness or straightness of a surface is possible using
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which principle is used to measure distance in electronic comparator?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which error is observed due to lack of squareness when depth is measured using depth micrometer?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following is true for interference fit?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  How is interference between shaft and hole calculated?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which among the following is used to create fringes in N.P.L. interferometer?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which type of light source is used in N.P.L. type of flatness interferometer?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which principle does Taylor-Hobson-Talysurf tester work on?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following methods is unreliable to evaluate the surface finish?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Calculate diameter of best wire for a Withworth thread of M 24 x 7 mm size.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following statements is true?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Calculate the tool width of a gear having 30 number of teeth and with module 5 mm.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts