Material Science Test Questions


Q.  What is meant by atomization?

a. Process of disintegrating molten metal into small particles by use of compressed air
b. Process of fusing small particles of metals into molten mass by water
c. Both A & B
d. None of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Relative motion between links is more than one direction which is unpredictable is known as
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Shaft with taper key is an example of
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  According to D' Alembert's principle, the body is in equilibrium position if
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  A connecting rod has periodic time of 1.5 sec/cycle for one oscillation. Calculate radius of gyration, when centre of gravity is at a distance of 500 mm from the small end.
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Which of the following condition is true for uniform wear theory?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Which theory is used to determine safe design of bearings?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Frictional torque transmitted by uniform wear theory is more than torque transmitted by uniform pressure theory
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Double block brake is a type of
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Which energy is absorbed by the brakes of an elevator during braking process?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  In single shoe brake, when is uniform normal pressure observed between block and drum?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Which type of brakes have wooden blocks placed inside flexible steel band?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  According to loop closure equation, in a closed loop mechanism the sum of relative position vectors for the links is
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Why is double Hooke's joint used?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  (ω cos θ) / n is the formula used to calculate
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Which of the following kinematic pairs is classified depending upon the mechanical arrangement between the links?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Which pairs are considered as higher pairs?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Cam and follower is an example of
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The equation j = (3/2)n – 2 represents relation between number of joints (L.H.S) and number of links (R.H.S). The chain is constrained if
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Trifilar suspension system is used to determine mass moment of inertia of
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The difference between which two factors denotes the correction couple?
Category: Mechanical Engineering Questions,   Published by: teswesm