Thermodynamics Test Questions

Q.  What is flash gas fraction?

a. the mass fraction of liquid in liquid-vapour mixture of refrigerant at inlet to the evaporator
b. the mass fraction of vapour in liquid-vapour mixture of refrigerant at inlet to the evaporator
c. the mass of vapour actually compressed to the mass of vapour should have compressed ideally
d. none of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  What is the inversion curve in isenthalpic expansion or Joule-Kelvin expansion?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which is the affecting factor for the fact that turbine work output is more than pump work input in vapour power cycle for the same pressure ratio?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which loss does present in actual vapour power cycle at the exit of the boiler and at the entry of the turbine?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  How can we differentiate Rankine cycle from Carnot cycle?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  How is the efficiency of the SI engine affected by change in specific heat ratio (γ) of the working fluid?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  For the same capacity engines, the compression ratio of diesel engine
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Rate of burning in the compression ignition engine can be controlled by
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  How is the heat added in the Diesel cycle?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The Brayton cycle which is used in aircraft, automotive is
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The heat required to melt 1 tonne of ice in 12 hours is equivalent to
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  One tonne of refrigeration is approximately equal to
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is the main reason behind subcooling of liquid refrigerant at the condenser outlet in vapour compression refrigeration system?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is the result of superheating of vapour at the evaporator outlet?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which expansion device is capable of regulating the flow of refrigerant according to the load on the evaporator?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which compressor is used, when volume flow rate of refrigerant is very large?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is the temperature at which the water vapour in the mixture of water vapour in air, starts condensing called?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The temperature of air recorded by thermometer when the bulb is covered by a cotton wick saturated by water is called as
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which temperature can be measured by an instrument called psychrometer?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is the purpose of using economizer in the boiler?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Homogeneous system
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts