Material Science Test Questions

Q.  What does primary creep in creep curve indicate?

a. Due to down deformation, resistance of metal increases
b. Due to down deformation, resistance of metal decreases
c. It represents high strain rate
d. It represents creep at constant rate


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  (ω cos θ) / n is the formula used to calculate
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following kinematic pairs is classified depending upon the mechanical arrangement between the links?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which pairs are considered as higher pairs?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Cam and follower is an example of
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The equation j = (3/2)n – 2 represents relation between number of joints (L.H.S) and number of links (R.H.S). The chain is constrained if
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Trifilar suspension system is used to determine mass moment of inertia of
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The difference between which two factors denotes the correction couple?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  On which factors does law of friction depend?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What are crank effort diagrams?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following statements is/are true?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which clutch is known as wet clutch?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In centrifugal clutches, when is the contact between shoe friction lining and surface of drum observed?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Calculate torque transmitted by the clutch having four shoes, which has spring force of 700 N and centrifugal force of 4000 N. Rim diameter is 560 mm and coefficient of friction is 0.3
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If brakes are applied on front wheels of a car and if it moves on a level road, then retardation of the car is calculated using the formula
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Determine the power transmitted if dead weight on brake is 70 kg and engine has a speed of 300 rpm. One end of the rope has a diameter of 0.05 m is attached to a spring balance which has reading of 150 N, diameter of drum is 1 m.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which parameters can be measured using a dynamometer?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Identify the type of absorption dynamometer ?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following statements is/are false?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In a Hooke's joint, maximum velocity ratio between driving and driven shaft is possible if θ is
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which relation is used to denote condition for equal speeds, when driving and driven shafts are connected by Hook's joint?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts