Basic Mechanical Engineering Test

Q.  What are the number of sliding and turning pairs in a slider crank mechanism?

a. 1 sliding pair and 3 turning pairs
b. 2 sliding pairs and 2 turning pairs
c. 3 sliding pairs and 1 turning pair
d. None of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Which of the following factors are not responsible for unbalancing in rotating systems?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Determine magnitude of balancing mass required if 250 mm is the radius of rotation. Masses of A, B and C are 300 kg, 250 kg and 100 kg which have radii of rotation as 50 mm, 80 mm and 100 mm respectively . The angles between the consecutive masses are 110° and 270° respectively.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What are discrete parameter systems?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In which type of vibrations, amplitude of vibration goes on decreasing every cycle?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following vibrations are classified according to magnitude of actuating force?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What are deterministic vibrations?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  According to which method, maximum kinetic energy at mean position is equal to maximum potential energy at extreme position?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Determine natural frequency of a system, which has equivalent spring stiffness of 30000 N/m and mass of 20 kg?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Magnification factor is the ratio of ______
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following statements is/are true? 1. Magnification factor is minimum at resonance 2. The maximum value of amplification factor increases as damping factor decreases 3. The maximum value of amplification factor increases as damping factor increases 4. Magnification factor is maximum at resonance
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is meant by geometric modeling?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Simulation is a process which _________
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following statements is/are true?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Seismometer can be used to measure acceleration of any instrument only if _____
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which type of monitoring system uses stroboscope to measure speed of the machine?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following conditions is/are to be satisfied by the seismometer for it to be used as velometer?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following methods can be used to reduce excitation level at the source?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following is a type of untuned vibration absorber?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which basic document describes general requirements for measurement and evaluation of machine vibrations using shaft measurements?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which among the following is not considered when reference standards are used in the field of mechanical vibration and shock, monitoring and analysis of machines?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts