Chemical Engineering Basics Mcqs

Q.  Uniform ramming of sand in green sand moulding process leads to____________________?

a. Reduced chance of gas porosity
b. Greater dimensional stability of the casting
c. Uniform flow of molten metal into the mould cavity
d. Less sand expansion type of casting defect


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  Which of the following is the most suitable abrasive for grinding high tensile strength materials ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The noble metals________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Unit of surface tension in S.I. unit is_________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Co-efficient of performance of a Carnot cycle refrigerator operating between – 23°C and + 27°C is ________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Lead is poured into the joint between two _______________ pipes ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  ______________ circuit is most commonly used to measure strain with the help of a strain gauge?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Basic open hearth furnace (BOF) is not used for producing ______________ steel?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Laser is a device to produce___________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following is the most wear resistant grade of carbide used for the cutting tools ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Thermal efficiency of an internal combustion engine is around ______________ percent?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Hydrogen in liquid steels is dissolved_________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Nickel and ______________ are the alloying element added in steel to increase its toughness?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The lightest non-inflammable gas is_________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The surface tension of a liquid, at critical temperature is____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  ‘Amortization’ in respect of financial obligation of a company means the_____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The same volume of all gases is representative of their_____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The function of neutral flux used in the pyrometallurgy of metal extraction is to increase the _____________ of the slag ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  For infinite parallel planes having emissivities ε1 & ε2, the interchange factor for radiation from surface 1 to surface 2 is given by__________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Wave length of X-rays is about 1 angstrom; however it cannot pass through a sheet of ________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following is an unconventional source of energy ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts