MCQs: Axial flow pump is started with its delivery valve________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Head developed by a centrifugal pump depends on___________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: In a centrifugal pump casing, the flow of water leaving the_______________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Reciprocating pumps are no more to be seen in industrial applications (in comparison to centrifugal pumps) because of____________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The efficiency of a centrifugal pump is maximum when its blades are__________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: When a piping system is made up primarily of friction head and very little of vertical lift, then pump characteristics should be__________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: If a pump is handling water and is discharging a certain flow Q at a constant total dynamic head requiring a definite B.H.P., the same pump when handling a liquid of specific gravity 0.75 and viscosity nearly same as of water would discharge_____________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The optimum value of vane exit angle for a centrifugal pump impeller is_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: In centrifugal pumps, maximum efficiency is obtained when the blades are_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: In a centrifugal pump, the liquid enters the pump__________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Low specific speed of a pump implies it is____________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: For small discharge at high pressure, following pump is preferred_____________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The horse power required in above case will be___________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Motion of a liquid in a volute casing of a centrifugal pump is an example of____________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Medium specific speed of a pump implies it is_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Indicator diagram of a reciprocating pump is a graph between________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Any change in load is adjusted by adjusting following parameter on turbine______________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The maximum number of jets generally employed in impulse turbine without jet interference is________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: High specific speed of turbine implies it is__________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Casting of a centrifugal pump is designed so as to minimize________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|