Railway Engineering Mcqs

Q.  Two important constituents in the com-position of steel used for rail are_________________?

a. carbon and silicon
b. manganese and phosphorous
c. carbon and manganese
d. carbon and sulfur


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  As compared to field rivets, the shop rivets are________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Efficiency of a riveted joint, having the minimum pitch as per IS : 800, is_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Bolts are most suitable to carry_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  When the bolts are subjected to reversal of stresses, the most suitable type of bolt is________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The effective length of a fillet weld should not be less than___________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A butt weld is specified by__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The slenderness ratio of a column supported throughout its length by a masonry wall is________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The effective length of a battened strut effectively held in position at both ends but not restrained in direction is taken as________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  According to IS Specifications, the maximum pitch of rivets in compression is_____________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The maximum slenderness ratio of a steel column, the design of which is governed by wind or seismic forces is________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  According to IS:800, in the Merchant Rankine formula the value of imperfection index (n) is_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The maximum slenderness ratio of a compression member carrying both dead and superimposed load is___________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  According to IS Specifications, the effective length of a column effectively held in position at both ends and restrained in direction at one end is taken as________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The actual thickness of butt weld as compared to the thickness of plate is usually________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  For a standard 45° fillet, the ratio of size of fillet to throat thickness is_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A circular column section is generally not used in actual practice because________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The best arrangement to provide unified behaviour in built up steel columns is by______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The use of tie plates in laced columns is_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Angle of inclination of the lacing bar with the longitudinal axis of the column should preferably be between____________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The effective length of a battened column is increased by_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts