Chemical Engineering Basics Mcqs

Q.  Tumbling is the process of improving the ________________ of the materials/parts ?

a. Surface finish
b. Fatigue limit
c. Creep limit
d. Surface cleanliness


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Which of the following is prone to cup and cone fracture ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Minimum safe distance between two liquid fuel storage tanks is equal to (where, H = height of the tank) ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Austempering process results in the formation of ________________ structure ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Good design of the casing of a centrifugal pump aims at minimising the __________________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The ratio of mass of a neutron to that of an electron is about 1839. What is the ratio of the mass of a proton to that of an electron ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Matte smelting is used in the extraction of_____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Carnot cycle is also termed as the constant _________________ cycle in thermodynamics?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Large diameter reinforced cement concrete (RCC) pipes are generally joined by ____________________ joint ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A dummy activity is used in PERT network to describe the_____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Unit of viscosity in CGS system is_______________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The refractory lining of the bottom in a basic electric arc furnace is made of___________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The specific gravity of coal depends mainly on its __________________ content ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In practice, the compression ratio of compression-ignition (CI) engine ranges from ______________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Brittleness induced due to the presence of sulphur in steel can be reduced by adding____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  With increase in temperature, the surface tension of water_______________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Compressed dry air is used as the cutting fluid, while machining____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  With increase in compression ratio, the volumetric efficiency of air compressor____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following has the least value of ultimate tensile strength (UTS) ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Current employed in resistance welding ranges from ____________________ kVA/cm2?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Presence of nickel & chromium in steel does not raise its _________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts