MCQs: Pick up the wrong statement?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: A fuel will detonate less if it has___________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The ash content in diesel oil should bot be more than_______________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Fuel consumption with increase in back pressure will________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: A 4-stroke diesel engine needs about following amount of air_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: With increase in speed of vehicle, the back pressure will________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Air injection in I.C. engines refers to injection of___________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The ratio of useful power; engine friction exhaust gas losses; cooling water, air and oil losses for a diesel engine is of the order of____________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The system of lubrication used for motor cycles and scooters is by________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The specific fuel consumption for a petrol engine first decreases with increase in fuel air ratio and then increases with further increase in fuel air ratio. The minimum value occurs in the range of__________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Diesel engines as compared to petrol engines require ______________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Auto-ignition reaction time for petrol engine first decreases with increase in fuel air ratio, reaches a minimum value and then increases with subsequent increase in fuel air ratio. The minimum value occurs in the region of________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Exhaust pipes of engines are covered with insulating marterial in order to_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The thermal efficiency of a two cycle engine as compared to four cycle engine is_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The m.e.p. of a petrol engine first increases as the fuel air ratio is increased and then decreases on further increase in fuel air ratio. The M.E.P is maximum in the zone of________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Solid injection in I.C. engines refers to injection of________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: For same power and same speed, the flywheel of a four stroke engine as compared to two-stroke I.C. engine will be________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The function of a distributor in an automobile is to__________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Leakage past the piston rings and valve seats in I.C. engines with increase in speed_______________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The cooling water requirement for diesel engine is of the order of________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|