Railway Engineering Mcqs


Q.  The width of foot for 90 R rail section is__________________?

a. 100 mm
b. 122.2 mm
c. 136.5 mm
d. 146.0 mm


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  If the thickness of thinnest outside plate is 10 mm, then the maximum pitch of rivets in tension will be taken as______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  When the axis of load lies in the plane of rivet group, then the rivets are subjected to________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Bending compressive and tensile stresses respectively are calculated based on_________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  When the axis of load lies in the plane of rivet group, then the most heavily loaded rivet will be the one which________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The difference between gross diameter and nominal diameter for the rivets up to 25 mm diameter is__________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  If the thickness of plate to be connected by a rivet is 16 mm, then suitable size of rivet as per Unwin’s formula will be__________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The heaviest I-section for same depth is_________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following types of riveted joint is free from bending stresses ?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  In a gusseted base, when the end of the column is machined for complete bearing on the base plate, then the axial load is assumed to be transferred to base plate__________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  By providing sufficient edge distance, which of the following failures of riveted joint can be avoided ?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  As compared to field rivets, the shop rivets are________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Efficiency of a riveted joint, having the minimum pitch as per IS : 800, is_________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Bolts are most suitable to carry_________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  When the bolts are subjected to reversal of stresses, the most suitable type of bolt is________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The effective length of a fillet weld should not be less than___________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  A butt weld is specified by__________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The slenderness ratio of a column supported throughout its length by a masonry wall is________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The effective length of a battened strut effectively held in position at both ends but not restrained in direction is taken as________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  According to IS Specifications, the maximum pitch of rivets in compression is_____________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The maximum slenderness ratio of a steel column, the design of which is governed by wind or seismic forces is________________?
Category: Civil Engineering Mcqs,   Published by: teswesm