Process Equipment & Plant Design Mcqs for Chemical

Q.  The wall thickness for a large high pressure pipeline is determined by the consideration of the____________________?

a. Axial tensile stress in the pipe
b. Forces exerted by static and dynamic action at bends
c. Circumferential pipe-wall tension
d. Temperature stresses


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  Cylindrical pressure vessels in horizontal condition is generally supported on a ________________ support?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Pick out the wrong statement pertaining to the comparative evaluation of performance of the packed tower and the plate tower ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Flanges are connected to pipes by _______________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In the downcomer of a distillation column, the minimum recommended residence time is about _______________ seconds?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The maximum liquid gradient over a tray must not exceed__________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In a thin cylindrical shell, the hoop stress is ________________ stress?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Pressure drop per tray in the atmospheric distillation column is about ________________ psi?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  n the agitators, the power required will be changed with the increase of diameter of agitator D. as ____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Pick out the correct statement___________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The circumferential (hoop) stress in a thin walled cylindrical vessel under internal pressure is______________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Vertical condenser is advantageous to the horizontal condenser from operation point of view, when________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  An increase in the liquid resistance to interphase mass transfer and a resultant reduction in plate efficiency is caused by______________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Overall tray efficiency of a distillation column is the ratio of the number of ___________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Fouling factor must be included in the calculation of overall design heat transfer coefficient, when the liquid__________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following is not a graphical method (but is an analytical method) for the calculation of theoretical number of stages in case of continuous binary distillation ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  For storing hazardous chemicals in large storage tanks, the minimum safe distance between the two tanks should range between ______________________ times the tank diameter?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If a single tube pass heat exchanger is converted to two passes; for the same flow rate, the pressure drop per unit length in tube side will _____________ times?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Rivets are generally specified by the____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Shortest distance between two tubes is___________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Bubble cap plate column is___________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts