Theory of Machines Test Questions


Q.  The values of velocity and acceleration of piston at near dead center for a slider-crank mechanism will be________________?

a. 0, and more than co2r
b. 0, and less than coV
c. 0, 0
d. cor, 0
e. none of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  The Hooke’s joint consists of ____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The e.g. of a link in any mechanism would experience_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Flexible coupling is used because _____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The type of coupling used to join two shafts whose axes are neither in same straight line nor parallel, but intersect is______________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  the chain is constrained when_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  In automobiles the power is transmitted from gear box to differential through _________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The Ackermann steering mechanism is preferred to the Davis type in automobiles because____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  When a ship travels in a sea, which of the effect is more dangerous___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  In gramophones for adjusting the speed of the turntable, the following type of governor is commonly employed_______________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Crowning on pulleys helps__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  In multi-V-belt transmission, if one of the belt is broken, we have to change the_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The indicator using Watt mechanism is known as________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Transmission of power from the engine to the rear axle of an automobile is by means of___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  In an ideal machine, the output as compared to input is_______________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  For fluctuating loads, welsuited bearing is_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Governor is used in automobile to_______________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Idler pulley is used___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The moment on the pulley which produces rotation is called ___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  T Jie horse power transmitted by a belt is dependent upon _________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Creep in belt drive is due to____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm