Surveying Mcqs

Q.  The two point problem and three point problem are methods of________________?

a. resection
b. orientation
c. traversing
d. resection and orientation


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  The methods used for locating the plane table stations are_______________? 1. radiation 2. traversing 3.intersection 4. resection The correct answer is
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In the cross-section method of indirect contouring, the spacing of cross-sections depends upon_____________? 1. contour interval 2. scale of plan 3. characteristics of ground The correct answer is ?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A metallic tape is made of ______________ ?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The shape of the camber, best suited for cement concrete pavements, is_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The stopping sight distance depends upon_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Coefficient of friction is less when the pavement surface is________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Camber in the road is provided for_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  On a single lane road with two way traffic, the minimum stopping sight distance is equal to______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The shoulder provided along the road edge should be_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  When the path travelled along the road surface is more than the circumferential movement of the wheels due to rotation, then it results in______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  For water bound macadam roads in localities of heavy rainfall, the recommended value of camber is_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The sequence of four stages of survey in a highway alignment is______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Nagpur road plan formula were prepared by assuming______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Compared to a level surface, on a descending gradient the stopping sight distance is_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The desirable length of overtaking zone as per IRC recommendation is equal to________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Select the correct statement______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Reaction time of a driver_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If the stopping distance is 60 meters, then the minimum stopping sight distance for two lane, two way traffic is_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If b is the wheel track of a vehicle and h is the height of centre of gravity above road surface, then to avoid overturning and lateral skidding on a horizontal curve, the centrifugal ratio should always be________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The ruling design speed on a National Highway in plain terrain as per IRC recommendations is_____________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts