Heat Transfer Questions

Q.  The total emissivity power is .defined as the total amount of radiation emitted by a black body per unit_______________?

a. temperature
b. thickness
c. area
d. time
e. area and time


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  The optimum value of vane exit angle for a centrifugal pump impeller is_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In centrifugal pumps, maximum efficiency is obtained when the blades are_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In a centrifugal pump, the liquid enters the pump__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Low specific speed of a pump implies it is____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  For small discharge at high pressure, following pump is preferred_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The horse power required in above case will be___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Motion of a liquid in a volute casing of a centrifugal pump is an example of____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Medium specific speed of a pump implies it is_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Indicator diagram of a reciprocating pump is a graph between________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Any change in load is adjusted by adjusting following parameter on turbine______________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The maximum number of jets generally employed in impulse turbine without jet interference is________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  High specific speed of turbine implies it is__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Casting of a centrifugal pump is designed so as to minimize________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Guide angle as per the aerofoil theory of Kaplan turbine blade design is defined as the angle between_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The flow rate in gear pump___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Reaction turbines are used for____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The angle of taper on draft tube is A. greater than 15° B. greater than 8° C. greater than 5° D. less than 8° E. less than 3°.___________________? The angle of taper on draft tube is
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In axial flow fans and turbines, fluid enters and leaves as follows________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Air vessels in reciprocating pump are used to__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  According to fan laws, at constant speed and capacity, the pressure and power vary_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts