Highway Engineering Mcqs


Q.  The thickness of bituminous carpet varies from__________________?

a. 20 to 25 mm
b. 50 to 75 mm
c. 75 to 100 mm
d. 100 to 120 mm


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  The approximate value of the ratio between direct tensile strength and flexural strength is_____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Air entrainment in the concrete increases________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Workability of concrete is inversely pro¬portional to______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The property of fresh concrete, in which the water in the mix tends to rise to the surface while placing and compacting, is called________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  To determine the modulus of rupture, the size of test specimen used is_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The percentage of voids in cement is approximately_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Modulus of rupture of concrete is a measure of_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  In order to obtain the best workability of concrete, the preferred shape of aggregate is_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  As compared to ordinary portland cement, high alumina cement has______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Bulking of sand is maximum if moisture content is about____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  1% of voids in a concrete mix would reduce its strength by about______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Finer grinding of cement______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Poisson’s ratio for concrete_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The factor of safety for______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The fineness modulus of fine aggregate is in the range of______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The compressive strength of 100 mm cube as compared to 150 mm cube is always_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  If a beam fails in bond, then its bond strength can be increased most economi-cally by___________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  If the depth of actual neutral axis in a beam is more than the depth of critical neutral axis, then the beam is called________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  If the permissible stress in steel in tension is 140 N/mm2, then the depth of neutral axis for a singly reinforced rectangular balanced section will be___________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Minimum grade of concrete to be used in reinforced concrete as per IS:456-1978 is_____________?
Category: Civil Engineering Mcqs,   Published by: teswesm