MCQs: A two stroke engine is usually identified by__________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: A two stroke crank compressed engine has following ports in the cylinder_______________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Scavenging air is supplied to a two-stroke engine at a density greater than that of atmosphere. This means the engine is__________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: In turbulence chamber in diesel engine__________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: If petrol is used in a diesel engine, then______________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Deposition of carbon in petrol engine cylinder would result in increase of__________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The part load efficiency of a carburettor is,___________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The basic requirement of a good combustion chamber is___________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The following type of carburettor is preferred_______________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The theoretically correct mixture of air and petrol is approximately ________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Carburretion is done to________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: With increase in engine speed, the ignition of spark in petrol engine has to be __________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Pick up false statement?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The property of a material which enables it to resist fracture due to high impact loads is known as__________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Guest’s theory of failure is applicable for following type of materials_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: If an unsupported uniform cross sectional elastic bar is subjected to a longitudinal impact from a rigid bob moving with velocity v, then a compressive wave of intensity sc is propagated through the bar as follows______________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Resilience of a material is important, when it is subjected to________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Other method of reducing shock load in the above case can be_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Brittle coating technique is used for_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The endurance limit of a material with finished surface in comparison to rough surface is_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|