Steam Boilers, Engines, Nozzles & Turbines Mcqs


Q.  The relative heat absorption for successively added equal areas of boiler convection heating surfaces____________________?

a. increases
b. decreases
c. remains unaffected
d. first increases and then decreases
e. first decreases and then increases


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  The proximate analysis of fuel lists__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Green coal, in order to be burnt, must be____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Sulphur in coal results in___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The behaviour of coal in a furnace is determained by_______________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Pour point of fuel oil is the____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Gusset stays in a boiler are provided to____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Sulphur content of fuels is very important to the plant operators because it____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  An economiser in a boiler______________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Spontaneous combustion is a phenomenon in which____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Ultimate analysis of fuel is determination of percentage of____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Which device is used in thermal power plants to reduce level of pollution___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The maximum discharge through a chimney occurs when the height of chimney is_____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  In locomotives, the draught is produced by_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Vacuum for reciprocating steam engines compared to steam turbines is__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The height of chimney in a power plant is governed by__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The function of injector used in small capacity boilers is to____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  In designing air preheater, the important design consideration is that_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The temperature of flue gases at air heater outlet should be__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  In a recuperative air preheater, the heat is transferred____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  With increase in load, convection superheater has_______________________?
Category: Mechanical Engineering Questions,   Published by: teswesm